DIY Bathroom Plumbing – Installing a New Showerhead

Of all the home plumbing repairs you could tackle, the replacement of an old showerhead with a new one is probably the easiest. A shower plumbing project is a good starter project for a number of reasons. No special tools are required, the necessary parts are pretty close to one size fits all, and if you do make a mistake and have a leak, the only thing that gets wet is your shower/bathtub. This is the perfect project for the novice home repair handyman to start with and can usually be completed in well under an hour.

The first step is to decide what type of shower head you want to replace. While most shower fixtures connect to a standard size pipe thread, you must make sure you have enough clearance for your new showerhead. If the stem (the portion of the pipe from the wall to the existing shower head) is short or close to the ceiling you will want to check before purchasing a large fixture.

The Tools You Need – For this project, you will need a wrench or pliers and some teflon tape. Depending upon the age of your existing fixture, you may also need to have a pipe wrench on hand as well. You may also want to have something available protect your fixture from the jaws of the wrench or pliers (a folded rag or piece of rubber from an inner tube work well)

Remove the Old Showerhead – If you have an older unit you probably have some rust, oxidation, or lime buildup that may make removal difficult. If the fixture does not readily unscrew, use two sets of pliers/wrenches (with the jaws of each protected as indicated above), one set on the stem and the other on the fixture. Apply equal pressure to both sides to until the showerhead starts to move. Be careful not to apply too much force as you do not want to break either the stem or existing showerhead. Once the shower head starts to turn you should be able to remove it by hand.

Clean and prepare the stem pipe – A little preparation here could save you quite a bit of time later if you decide to replace the showerhead again. Clean the threads of the stem of any rust or lime and apply teflon tape to the threads. This will help the new showerhead install easily, provide a good seal, and make it easier in the future if you ever have to replace the shower head again.

Install the New Shower – If you selected a simple replacement showerhead all that remains to be done is to screw the new fixture onto the prepared pipe stem. Make sure not to over-tighten when you are installing this – hand tight plus a quarter or half turn is probably all you need. If you have purchased a more sophisticated fixture like a shower massage wand you may have a few pieces to install. Make sure that you apply teflon tape to all threaded connections (unless otherwise specified by the manufacturer) to ensure a good seal.

Test It – Before putting your tools away and jumping in the shower take a few minutes to make sure the job is done. Turn on the water and check each of the connections for leaks. If you find any, usually they will be fixed by tightening the connection another quarter or half turn. If this does not address the problem you may need to check for a missing or worn washer.

Basic DIY Bathroom Plumbing Mistakes to Fix

Bathroom plumbing is a challenging task to undertake as it involves a great deal of awkward tasks related to leaking of the shower-head, toilet or bathtub repair, installation of new bath fixtures, etc. All such problems with plumbing can be avoided, if you keep basic issues in mind. After kitchen, bathroom becomes the frequently used portion of the dwelling.

Thus, it leads to many small and major plumbing problems faced by the proprietor. To overcome all such matters, he may attempt to fix it himself or ask the assistance of a professional plumber. But if the repair is done by yourself it might face an error making it an expensive fix.

Let us go through some of the basic DIY plumbing mistakes and ways to fix it.

Use of Teflon Tape – it is used to repair different leakages in the toilet and make it drip-proof. It is ideal for fixtures or repair and maintenance of showers. Fixing minor issues to kitchen or faucet repairs. It perfectly covers all the leakage and breakage of taps or shower through wrapping around a tape over it.

DIY Approach – plumbing problems related to toilet repair, re-piping of the kitchen drainage system undertaken by yourself may lead you forget certain steps that can be regretted later. Some installation, repair and maintenance to pipe sizing make you go wrong during the process. This led to inadequate approach of working forcing you to get the help of a plumber.

Use of Inadequate piping material – whenever you go to the bathroom or kitchen repair plumbing, you need to carefully analyse your working theory to it. For example fixing or connecting the galvanised or copper pipe with a connector. You need to remember the step by step procedure to Piping material.

Proper Level of Plumbing and Fixture installation – everyone has a different way of going to a toilet or bathroom repair, a time comes when they are so engulfed with their maintenance practice that they take the wrong decision to its fitting that sometimes make them to uninstall the repaired fixture unknowingly.

Improper installation of Floors and drainage lines – All those crazy people who wish to undertake different means to the renovation of drainage lines to different routes always come under a grave situation like noisy or leaking flush that disturbs the whole outlet plumbing. It is advised not to route plumbing lines until and unless the plumber enquire you to do so.

Avoid last-minute plumbing tasks – Taking up plumbing installation and repair at the tenth hour always led you make irreparable mistakes. Slow down and take time to follow the plumbing repair steps aesthetically. Carefully examine the affected area and then formulate simple steps to its adequate fixing and mending.

Why Leave Plumbing Installation to the Pros

Plumbing installation is a job often best left to the professionals. The good news is you do not have to do the work. Rather than trying to find the right U bend and ensuring there is not the smallest drip of water coming out of the faucet, just let the professionals do the work for you. In doing so, you will feel more comfortable with the outcome and your family will not have to worry about the long-term risks of not having a professional handle this job. There are some key benefits to turning to a pro for this type situation.

Remodeling Jobs Done Right

One of the main reasons to have a professional handle the plumbing installation tasks necessary is that these professionals will work with you to get the job done properly the first time. Perhaps you are changing out an old shower for a new one. You think the job is easy enough so you rip out the existing shower to replace it. You did not notice the drain connection and you’ve created a big problem as a result. The expertise these professionals have is one of the most valuable reasons to turn to them for a large-scale job. You need to feel comfortable that this professional is going to get the job done properly.

Avoiding Water Problems

One of the biggest enemies in the home is water. If just a small amount of water or moisture builds in a space in a short amount of time, this can lead to mold problems. Mold is dangerous for families and it can complicate the health of those who have asthma or allergies already. However, if you do not handle that moisture issue with the water pipe under the sink, this can become a very big problem before long. You may not even realize something is wrong for weeks. That’s a costly repair you do not need.

They Provide Guarantees

What if the plumber does something wrong? Then what do you have to worry about? For example, if you have a new section remodeled in your home, you may have pipes and drains installed. If something goes wrong with this installation and you have allowed a professional to do the work for you, he or she will be responsible for fixing the damaged caused. This may include damage to fixtures, structures and even the drywall itself. This can save you money.

For installation jobs including those relating to bathrooms and kitchens, drains and spigots, it is best to leave the job to the pro. Contact a plumbing professional to ask about your task. You may find it is very much worthwhile to invest in this professional now.